Digital Energy Meter Single Phase Electric LCD Kwh Wattmeter Power Consumption Tester 4P RS485 Din R

Feature: 1. ACCURATE AND ADJUSTABLE: The digital energy meter adopts LCD display to accurately measure active power, meter address, baud rate and check bit can be modified 2. WIRING AND INSTALLATION: Energy meter adopts single phase 4P wire connection and 35mm guide rail installation, with accuracy up to 1 level 3. PERSISTENT STORAGE: The pulse constant of the electric energy meter is 400imp/1000imp, and the data storage time is >20 years 4. ACCURATE MEASUREMENT: This single phase electricity meter adopts microelectronic and digital processing technology to measure electric energy, to ensure accurate and reliable measurement 5. TECHNICAL PARAMETERS: Voltage of energy meter is 220V 50Hz, current from 15-60A, measuring energy range from 0.0-99999.0kwh Specification: Item Type: Digital Energy Meter Model: DDM75SR Number of Phases: Single phase Relative Humidity: ≤95% Ambient Temperature: -35~65℃ Accuracy: Level 1 Voltage Specification: 220V 50Hz Current Specification: 15-60A Maximum Working Current: 100A Measured Energy Range: 0.0-99999.0kwh Indicate Current Specification: Reference current(maximum current) Insulation Performance: AC voltage 4KV, 1 minute, 1.2/50us waveform impulse voltage: 6KV Data Display: LCD display Installation Mode: Rail installation Package List: 1 x Digital Energy Meter 1 x User Manual Note: 1. During meter installation, connect cables according to the wiring diagram in the user manual. 2. The instrument should be installed in a dry and stable place, can be installed indoors, avoid direct sunlight, humidity, heat, mold, smoke, dust, sand and corrosive gas. 3. It can be installed and used after the test seal. If it is not sealed or the storage time is too long, the test instrument will be tested again. 4. Only experienced electrician or professional technician can install the meter. Please read the manual. 5. Must be installed on refractory wall, not easy to shake. 6. It is recommended to use copper wire input when wiring, so as to avoid burning meter caused by poor contact. 7. When the meter is correct, the indicator lights up. The load capacity of the meter is between 0.05lb and lmaximum. Excessive capacity will cause burnout.