ElecGear 8pcs FU 10K Replacement Potentiometer 4pcs Additional Drift Correction Variable Thumbstick Sensor Repair Part for FU Analog Joystick

---------------------------------------------------------------------- 【JOOM Approved! Sold & Shipped by Trusted Japanese Sellers】

🔹 Operated by Verified Japanese Sellers – Approved by JOOM, our experienced Japanese sellers provide reliable service. 🔹 Direct Shipping from Japan – Carefully packed and promptly shipped straight from Japan. 🔹 Japanese-Standard Quality Control – Strict inspections ensure only high-quality products reach you. 🔹 About Included Manuals – If a manual is included, it will primarily be in Japanese. We recommend using image translation apps if needed. ---------------------------------------------------------------------- 【FU 10KΩ Potentiometer】 – Replacement variable resistor is manufactured by Favor Union (FU). Compatible with FU analog joysticks. This 10K ohm version is found on some PS3, PS4 DualShock controllers. FU reported that this orange sensor is also used in some Switch Pro, Hori, PDP, and BDA (Power A) controllers 【Compatibility】 – FU sensor has two different resistance values. This 10K version was printed in 103. Please make sure the value is approximately 10K ohm before ordering. (Note: If you find a FU joystick inside, please choose the 2.3KΩ version for some PS5 DualSense. The orange potentiometer made by FU is not compatible with the joystick made by ALPS.) [Additional Resistor] – Due to the complex moving mechanism and daily wear and tear, drift eventually occurred. Calibration in controller settings may not work. Packed with 10 compensation resistors to solve potential problems at hardware level. Solder one or two parallel small resistors to the potentiometer in opposite directions to the drift. Helps correct 3-5 degree drift. Please see the instruction photos 【For most joystick problems】 – If your controller has creep, stutter, blind spots, dead spots, dead zone problems, or you need to replace the 3 pin trimmer potentiometer sensor. tear. It is much easier to unsolder the unit with only 3 pins than to replace the entire module with up to 14 prongs [Replacement Reminder] – Make sure you have basic soldering skills and desoldering supplies such as an electronics soldering iron or small solder. Use pliers to separate the problematic sensor from the thumbstick component. A metal pick will help clear the holes in the PCB. Re-soldering a new unit is easy. Don't forget to adjust the new control stick in settings FU 10K Potentiometer 8x OEM replacement variable resistor was made by Favor Union (FU). It fits analog joysticks made by FU. This 10K ohm version was found in some PS3, PS4 DualShock controllers. FU reported that this orange sensor was also used in some Switch Pro, Hori, PDP, BDA (Power A) controllers 1.Solve most of joystick problems: 80% chances of joystick problems were caused by the potentiometer. In another words, the rotary mechanism and the tactile switches are not the problem. You can simply replace the side potentiometer sensor alone to solve most of the joystick problems 2.Additional resistors included: Complicated moving mechanism and daily wear and tear can cause drifting, and even new potentiometers can not be 100% balanced. Calibrating in controller settings might not work. Please solder one or more paralleled resistors at the opposite direction against drifting Compatibility Notes: 1.FU potentiometers do not work with joysticks made by ALPS 2.FU sensors come in two different resistance values. This 10K version was printed 103. Please make sure the resistance value is about 10K ohm before ordering 3.Please choose 2.3K version for some PS5 DualSense with FU joystick inside